The ANYCUBIC Original Heatbed is a vital accessory for the KOBRA FDM 3D Printer. With its advanced heating technology and precise temperature control, this heatbed ensures optimal adhesion for your 3D prints. Say goodbye to warping and failed prints, and hello to consistent and high-quality results.
works perfectly. this bed is the bare aluminum with heater.
you will still need a new magnetic sticker.
and I suggest removing and reusing the old wire protector that holds your cables out from the bed to protect them from kinking and breaking the solder points.
overall about 45 min start to finish to replace.
highly recommended and was in stock when the anycubic website was completely sold out.
thank you!
K
Kane Auer
Good table. There are no questions about quality.
R
Raquel Leuschke
Did not come
A
Amani Goodwin
Everything in correct measure
E
Edd Ernser
Exactly in time, everything is working, the table is smooth, thank you!
Choosing a selection results in a full page refresh.
